Programming The Handle Buttons - Bernina Q 20 User Manual

Setting up the machine
> To activate the KickSstart function, tap. «KickStart»
> To start the machine, press the foot control briefly with your heel.
> To stop the machine, press the foot control briefly with your heel again.
> To end KickSstart function, touch the screen or press the foot control down at the front.
Please note
• As long as the KickSstart function is active, the function programmed for the back kick will be
• The KickSstart function will be ended immediately in case the active monitoring function reports an error
• The KickSstart function will be ended immediately in case the foot control cable is unplugged.
• If no sewing is being carried out in the BSR modes, the machine will switch to standby mode after
• If no sewing has been carried out for 60 seconds, the kick-start function will be ended automatically. The

2.4 Programming the handle buttons

NOTICE! For Frame model only
There are 2 buttons on each handle that can be programmed with different functions.
> Switch on the machine and wait until it starts up.
> To program the buttons, repeat the following steps for all buttons.
26
– The KickSstart screen appears. The selected quilting mode will be displayed.
– If a BSR mode has been selected, the machine will start sewing using the selected settings as soon as
the fabric is moved.
– If manual mode has been selected, the machine will start sewing immediately.
– The machine will stop, but KickSstart function will remain active.
– The sewing screen will be displayed.
– The KickSstart function will be deactivated.
– The function programmed for the back kick will be active.
deactivated. The back kick then serves only to start and stop the machine.
(e.g. thread break or bobbin empty).
seven seconds. This means that the machine will not start sewing automatically if the fabric is moved.
End standby mode with another back kick.
KickSstart screen will disappear.