Connecting The Authentication Device - Epson WF-C8690 Series Hardware Setup Manual

Hardware Setup Guide
3. Secure it with two screws.
4. Attach the enclosed double-sided tape on top of the dedicated authentication device stand.
Peel off the other side of the seal when installing the authentication device.

Connecting the authentication device

You can connect the authentication device by using a USB cable.
Caution:
!
❏ Use a product with the same model number as the authentication device that was used to confirm the
authentication card for the authentication device connected to the MFD.
❏ Make sure you connect the authentication device to the service port on the back of the MFD. It will not work if it
is connected to a different USB port.
3. Authentication Device
13