Steps
1. Align and place the power button, along with its cable, on the slot of the palm-rest and keyboard assembly.
2. Slide the power-button cable into the connector on the fingerprint reader-board and close the latch to secure the cable.
3. Align the screw holes on the power-button bracket with the screw holes on the palm-rest and keyboard assembly.
4. Replace the two screws (M1.6x2.5) that secure power-button bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the
I/O
board.
2. Install the fan.
3. Install the
heat
sink.
4. Install the
base
cover.
5. Follow the procedure in
Fingerprint reader daughter-board
Removing the fingerprint reader daughter-board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
heat
sink.
4. Remove the fan.
5. Remove the
I/O
board.
About this task
The following image indicates the location of the fingerprint reader daughter-board and provides a visual representation of the removal
procedure.
40
Removing and installing components
After working inside your
computer.
Before working inside your
computer.