Connect Power - Broan FRESH IN BASIC FIN-180B Installation Instructions Manual

3.2 C
ONNECTING THE INSULATED DUCTS TO THE UNIT
1. Slide the inner flexible duct over the port and tie it using a tie-wrap.
2. Pull the insulation over the outer ring of the port without compressing it.
3. Use duct tape to seal the outer membrane of the insulated duct to the outer ring of the port.
��
Avoid blocking the test ports with the duct tape.
Test ports
VJ0151
Make sure the outdoor intake hood is at least 12 inches above the ground and 6 feet away
from any of the following: Dryer exhaust, high-efficiency furnace vent, central vacuum
vent, gas meter exhaust, gas barbecue-grill, any exhaust from a combustion source,
��
Make sure that the outdoor intake hood is easily accessible for annual maintenance. If located above
the first floor, place it close to a window or balcony to allow ease of access.
3.3 C P
ONNECT OWER
��
If desired, the power can be related to an ON/OFF wall switch. Do not use this unit with a dimmer
switch or any other type of control.
3.3.1 FIN-180B
Plug the unit power cord into a mating 3-prong grounding receptacle.
garbage bin and any other source of contamination.
⚠
WARNING
8 8