Software Update - Fostex MR-16HD Service Manual

& Service Manual

3. SOFTWARE UPDATE

1) Connect the AC power cable to the AC IN connector.
2) Press the MR16 power switch.
3) Press the [MENU/ENTER] dial to enter the MENU mode.
4) Rotate the [MENU/ENTER] dial and select the "USB" menu.
5) Press the [MENU/ENTER] dial.
6) Rotate the [MENU/ENTER] dial and select the "Disk Protect"
menu.
7) Press the [MENU/ENTER] dial and set "Disk Protect" to "Off" by
rotating the [MENU/ENTER] dial. Then, press the [MENU/EN-
TER] dial. With this setting, the Disk Protect mode is turned off
indicating the condition that the software update fi le can be copied
to the MR16 internal HDD.
8) Rotate the [MENU/ENTER] dial to select the "< < Back" menu and
press the [MENU/ENTER] dial.
9) Rotate the [MENU/ENTER] dial and select the "USB Device
Mode" menu.
10) Press the [MENU/ENTER] dial. If MR16 is correctly put into the
USB mode, the display on the right will appear on the LCD. Now
MR16 is ready to connect to PC or Macintosh.
11) Connect the USB cable from the MR16 USB port to PC on which
Windows XP/2000 is running or Macintosh on which OS X is run-
ning.
CAUTION: MR16 can be connected to PC on which Windows XP/2000 is running or Macintosh on which
10
OS X is running for software update as well as audio data transfer. Of course PC/Macintosh
has to be equipped with a USB port.
INPUT A SEL
GTR CLEAN MIC/LINE
GTR DIST
USB USB HOST MIDI OUT DIGITAL OUT FOOT SW
USB port
USB port