Table of Contents
Advertisement
MR16 Supplementary manual
4)
Use the [MENU/ENTER] knob to select
"CD Burn " and press the [MENU/ENTER]
knob.
The display now shows the Burning mode
selection screen.
You can select between "Track at once" and
"Disk at once" (see the previous page).
<Note>:
If "Not Mounted" is shown when you
select "USB HOST " using the [MENU/ENTER]
knob in step 3) above, an external CD-R/RW
drive is not connected to the MR16 correctly.
If you press the [MENU/ENTER] knob in the
above condition, the following message pops
up.
In such a case, check the USB cable connec-
tion while the MR16 stops accessing to the
HDD drive or CD-R/RW drive. Then confirm-
ing that the display does not show "Not
Mounted", press the [MENU/ENTER] knob.
5)
Use the [MENU/ENTER] knob to select the
desired burning mode and press the
[MENU/ENTER] knob.
The display now shows the screen for selecting
a stereo WAV file in the "2 MIX folder" of the
current song. In the screen example below, only
one stereo WAV file is stored.
(for the MR16 without a CD-R/RW drive)
6)
10
<Note>:
When more than one stereo WAV file
is stored in the "2 MIX folder" (as shown in the
example below), you can use the [MENU/EN-
TER] knob to select a desired file for "CD Burn"
(The maximum number of displayed files in the
list is ten).
Use the [MENU/ENTER] knob to select the
desired WAV file and press the [MENU/ENTER]
knob.
The unit starts writing the file to the CD-R/RW
disc. Depending on the selected burning mode,
either of the following screens is shown.
While the unit is writing data to the disc,
"Writing..." is popped up and " ACC " is flashing
on the screen.
Also the ACCESS indicator of the CD-R/RW drive
is flashing. Do not turn off the power or press
the eject switch of the drive while writing.
While writing data to the disc, any operational
keys of the MR16 are disabled.
Now writing in the Track at once mode
Now writing in the Disk at once mode
Advertisement
Table of Contents
