Maintenance Schedule - Shark Navigator Lift-Away NV350 Series Owner's Manual

Lift-Away® Cleaning
with Floor Nozzle
Fig. 16
1 Press the Lift-Away button and lift off
the pod.
2 Attach the floor nozzle onto the end of
the wand. (Fig. 16)
3 Move the selector switch to Setting I to
turn on power.
NOTE: The brushroll will not spin in Lift-
Away mode.
s h a r kc l e a n . c o m
Storage
Upper
Cord
Clip
Lower
Cord
Clip
Fig. 17
1 Attach pod to floor nozzle to go into
upright mode.
2 Rotate the upper cord clip to its upright
position and coil the power cord loosely
around the two clips. Clip the plug onto
the cord to secure. (Fig. 17)
3 Store the dusting brush and the crevice
tool on the mounts on the accessory
holder.
4 Store your vacuum cleaner safely in a cool,
dry area where it will not be a hazard, will
not be damaged, and will not cause damage
to anyone or anything.
NOTE: Empty dust cup after cleaning and
prior to storing. (See Maintenance section
for instructions.)
Maintenance
COMPONENT

MAINTENANCE SCHEDULE

1 Pre-Motor Foam and Rinse and air-dry every 3 months under normal use.
Felt Filters
2 Post-Motor HEPA Filter
Clean once every year or as needed.
Fig. 18
Fig. 19
Emptying The Dust Cup
The dust cup needs to be emptied each time
you vacuum and periodically during cleaning,
when the dust cup appears full.
1
Remove the dust cup by lifting the side
latches. (Fig. 18)
2 Hold the dust cup over a trash receptacle
and press the bottom door release button.
(Fig. 19) Tap gently to empty contents.
Press the door shut again until it clicks
into place.
3 If needed, turn the dust cup upside down
over the trash receptacle and press the
top door release button. (Fig. 20) Tap
gently to remove contents.
4 Replace the dust cup on top of the pod.
Hook the two latches onto the tabs on the
sides of the dust cup and push down to lock.
Screen
Filter
Pre-Motor
Foam Filter
Felt Filter
Fig. 20
Post Motor
HEPA Filter
Fig. 21
Cleaning The Pre-Motor Filters
1 Remove the dust cup.
2 Pull the 2 filters out from the top of the
pod. (Fig. 21)
3 Rinse the filters thoroughly in lukewarm
water until the water runs clear.
NOTE: Filter material will discolor over
time. This is normal, and will not affect
performance.
4 Squeeze out excess water and let air-dry
for at least 24 hours before replacing.
DO NOT use a hair dryer or other heating
methods to dry.
5 Reinsert the felt filter first, then the
foam filter.
6 Replace the dust cup.
s h a r kc l e a n . c o m