Configuring Interfaces - Fortinet FortiGate FortiGate-800 Administration Manual
Fortinet fortigate fortigate-800: user guide
Hide thumbs
Also See for FortiGate FortiGate-800:
- Installation and configuration manual (336 pages) ,
- Install manual (64 pages) ,
- Technical note (12 pages)
Table of Contents
Advertisement
Interface
Configuring interfaces
54
Use the following procedures to configure FortiGate interfaces and VLAN
subinterfaces.
•
To bring down an interface that is administratively up
•
To add interfaces to a zone
•
To add an interface to a virtual domain
•
To change the static IP address of an interface
•
To configure an interface for DHCP
•
To configure an interface for PPPoE
•
To add a secondary IP address
•
To add a ping server to an interface
•
To control administrative access to an interface
•
To change the MTU size of the packets leaving an interface
•
To configure traffic logging for connections to an interface
To add a VLAN subinterface
See
"To add a VLAN subinterface in NAT/Route mode" on page
To bring down an interface that is administratively up
You can bring down physical interfaces or VLAN subinterfaces. Bringing down a
physical interface also brings down the VLAN subinterfaces associated with it.
1
Go to System > Network > Interface.
The interface list is displayed.
2
Select Bring Down for the interface that you want to stop.
To start up an interface that is administratively down
You can start up physical interfaces and VLAN subinterfaces. Starting a physical
interface does not start the VLAN subinterfaces added to it.
1
Go to System > Network > Interface.
The interface list is displayed.
2
Select Bring Up for the interface that you want to start.
To add interfaces to a zone
If you have added zones to the FortiGate unit, you can use this procedure to add
interfaces or VLAN subinterfaces to the zone. To add a zone, see
page
59. You cannot add an interface to a zone if you have added firewall policies for
the interface. Delete firewall policies for the interface and then add the interface to the
zone.
1
Go to System > Network > Zone.
2
Choose the zone to add the interface or VLAN subinterface to and select Edit.
3
Select the names of the interfaces or VLAN subinterfaces to add to the zone.
4
Select OK to save the changes.
01-28006-0008-20041105
System network
65.
"To add a zone" on
Fortinet Inc.
Advertisement
Table of Contents
