Acquiring Satellite Signals - Garmin A03598 Quick Start Manual

Plug the small end of the power cable
2
into the mini-USB port on the charging
clip cable.
Plug the power cable into a power
3
source.
The status LED is solid red when the
collar is charging.
After the status LED turns solid green,
4
remove the charging clip from the
collar.

Acquiring Satellite Signals

Both the collar and handheld device must
acquire satellite signals before you put the
collar on your dog. Acquiring satellites can
take a few minutes.
Go outdoors to an open area.
1
Turn on both devices (page 2).
2
Select the power key on the handheld
3
device.
Quick Start Manual
shows the GPS signal strength.
When the collar has acquired satellite
signals, the status LED flashes a double-
blink or triple-blink in green.
Adding a Dog to the A03595 Handheld
The handheld device can track up to 20
dogs with dog collar devices. If you
purchase additional dog collar devices,
you can add them to the handheld device.
Bring your dog collar device within
1
range of the handheld device.
NOTE: The devices should be close
enough to touch.
Select DOG.
2
Select Add Dog.
3
Follow the on-screen instructions.
4
NOTE: An error message could
appear if there is a conflict with the ID
number of another dog.
After pairing is complete, you can add the
dog collar device to additional handheld
devices using the dog collar device track
code or control code. For more
information, go to www.garmin.com
/manuals/XXXX.
3