Ranger Fisherman Series Owner's Manual page 59

entered correctly or "1" and "4" was not depressed at the same time, or
too much time elapsed after entering in the user code before pressing the
"1" and "4" . Turn the system off by entering in the code and press stop,
after the LED is not lit by the stop button. Start at the beginning of this
section again.
After the flashing of the stop LED is obtained, enter in the new four
digit number followed by the start button, and then re-enter the four digit
number followed by the start button.
"X-X-X-X"
After pressing the start button the second time, the system will go into
accessory mode. If it does not enter accessory mode, type the current
user code in and press the stop button, then proceed to the beginning of
this section.
Navigation Lights
The switch labeled "Nav./Anchor" on the bow and console keypads
controls the operation of the navigation lights. On the first key press, the
bow navigation and stern anchor lights will turn on. On the second press,
the bow lights will turn off and the anchor light will remain on. On the third
key press, the anchor light will turn off.
Aerator System
Pressing the livewell key will activate two aerator pumps; pressing
this button again will turn off the aeration pumps. Pressing the livewell
timer button will automatically turn on the aeration pumps and the timer
in the "L" setting. The timer can be adjusted in three increments - "L, M,
and H". The "L" setting is one minute on then two minutes off. "M" is five
minutes on and one minute off. "H" is 15 minutes on and two minutes off.
Fuel Level
The switch labeled with an image of a fuel pump on the console
keypad controls which tanks' fuel will be displayed by the fuel gauge.
When the switch is pressed it will toggle between tank 1 and tank 2. Tank 1
will be on the starboard side and 2 will be on the port side. On models with
only 1 fuel tank, the number 2 position will cause the gauge to read empty.
Bilge System
The switch labeled with an image of the water leaving the sump of the
boat controls the bilge pumps in the boat. Pressing this button once will
activate a manual bilge pump; pressing again will activate the auto bilge
and the manual bilge; pressing again will turn off all bilge pumps. The
automatic bilge pump float switch only has power when the main circuit
breaker is in the on position. The float switch is located in the sump of the
boat.
Electrical System
"Start" "X-X-X-X"
59
"Start"