Remote Start Ready Mode; Enter & Exiting The Vehicle - Remote Start Ready Mode; Cancelling Remote Start Ready Mode - Prestige PE2LEDZ Owner's Manual

Apsrs rf upgrade kit
Hide thumbs Also See for PE2LEDZ:
Table of Contents

Advertisement

Remote Start Ready Mode must be enabled if your vehicle is equipped with a
manual transmission.
Remote Start Ready Mode - Manual Transmission Vehicles Only
To activate the remote start function, the system must first be in Remote Start Ready
Mode. Follow the steps below to enter remote start ready mode.
1. While the engine is running by the ignition key;
a.
b.
2. With your foot off the brake pedal, press and release the
activate the remote start. The remote will beep 4 times and the parking lights
will turn on to confirm the system has remote started.
3. Remove the keys from the ignition, the vehicle will remain running.
4. Exit the vehicle and close all vehicle doors.
5. Within 1 minute of step 1, press the
The vehicle will shutdown and sound 2 short chirps then 1 long chirp to confirm
ready mode is set.
To Enter & Exit the Vehicle while (Manual Transmission) Remote Start Ready
Mode is already active without cancelling Remote Start Ready Mode.
If ready mode has already been activated and you need to enter the vehicle, possibly
to retrieve an item, and will exit the vehicle without driving it, you can keep ready
mode active by following the steps below.
1.
With Ready Mode already previously set, activate the remote start.
2.
While under control of the remote start open vehicle door to retrieve
items.
3.
Exit the vehicle and close all doors.
4.
Press the
the system will verify all doors have been closed then will emit the 2
short/1 long tone and light flash pattern indicating Manual Transmission
Ready Mode is active.
Note: If the 2 short/1 long tone is not heard then Ready Mode has not been
set.
Cancelling Remote Start Ready Mode - Manual Transmission Vehicles Only
The system will exit remote start ready mode if any of the following occur:
Open any door
Open the hood or trunk (if connected)
Press the brake
Release the parking brake
Turn the ignition ON
2019 Voxx Electronics Corporation. All rights reserved.
Place the transmission in neutral.
Set the parking brake
button, the unit waits 3 seconds and then shuts down,
button to lock the vehicle's doors.
button to
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pe1m2ecdz

Table of Contents