Table of Contents
Advertisement
3.4
Drive mounting
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes.
See
Figure 4
for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:
• Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.140 in (3.56mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 in-lb).
3.4.1
Mechanical specifications
Refer to Figure 4 for detailed mounting configuration dimensions. See Section 3.4, "Drive mounting. "
Weight:
10TB & 8TB models
These dimensions conform to the Small Form Factor Standard documented in
Note
SFF-8301 and SFF-8323, found at
4X 6-32 UNC 2B
3 MIN THREAD DEPTH
.14 MAX FASTENER PENETRATION
MOUNTING HOLE.
MAX TORQUE 6 IN/LBS
2X 3.000 ± .010 in
76.20 ± .25 mm
2X 1.625 ± .020 in
1.432
41.28 ± .51 mm
.127 ± .010 in
3.23 ± .25 mm
1.028 in MAX
26.11 mm
.138 ± .015 in
3.51 ± .006 mm
Figure 4.
Mounting configuration dimensions
The image is for mechanical dimension reference only and may not represent the actual drive.
Note
Seagate SkyHawk AI Product Manual, Rev. F
1.43 lb
www.sffcommittee.org
B
C L OF CONN
.814 in
20.68 mm
2.000 in
C L OF DRIVE
50.80 mm
3.750 ± .010 in
95.25 ± .025mm
4.000 ±.010 in
101.60 ±.25 mm
2.000 in
50.80 mm
C L OF DRIVE
650 g
2X 4.000 ±.010 in
101.60 ±.25 mm
2X 1.122 ±.020 in
28.50 ±.51 mm
.250 ±.010 in
Y
6.35 ± .25 mm
Z
Z
5.787 in MAX
146.99 mm
Y
2X 6-32 UNC 2B
3 MIN THREAD DEPTH
.14 MAX FASTENER PENETRATION
MOUNTING HOLES BOTH SIDES.
MAX TORQUE 6 IN/LBS
25
Advertisement
Table of Contents
