FoodSaver V365 Quick Start

Additional Features & Tips
For more usage tips and safety information, please refer to the FoodSaver Reference Guide or visit our website at www.foodsaver.com.
Removable Drip Tray
The Removable Drip Tray
Channel , making cleanup easy when small
(D)
amounts of liquids are inadvertently pulled into
Vacuum Channel during vacuum process (see
FoodSaver Reference Guide for tips on preventing this).
Tips on Sealing a Bag
Make sure you've placed the bag in the proper
When making a bag from a roll, make sure end
place.
of cut piece is on Sealing Strip, not over rubber gasket
or in Vacuum Channel.
Prevent moisture or liquid from being pulled into
the Vacuum Channel or trapped in the seal.
pre-freeze moist foods such as raw meat for 1-2
hours before vacuum packaging, or place a folded
paper towel between food and end of bag to absorb
excess liquids. Just be sure to leave at least 3 inches
Tips on Removing Air from a Bag
Make sure you've placed the bag in the proper
When vacuuming and sealing a bag, make sure
place.
open end of bag is inside Vacuum Channel.
Check for wrinkles in the bag along the Sealing
Wrinkles in seal may cause leakage and allow
Strip.
air to come back into bag. Check for wrinkles in bag
along Sealing Strip before closing lid and vacuum
packaging. If you find wrinkles after sealing bag, sim-
ply cut bag open and vacuum package again.
Copyright © 2004 Tilia, Inc. All rights reserved. This material may not be reproduced or redistributed in any fashion without the express written consent of Tilia, Inc.
FoodSaver and the Freshness Shield logo are trademarks or registered trademarks of Tilia Int'l, Inc. in the United States and other countries. All other trademarks are
property of their respective owners. Tilia, Inc. and Tilia Int'l, Inc. are Jarden companies.This product is protected by one or more of the following Patents:
U.S. RE 34,929; 4,660,355; 4,941,310; 5,655,357; 6,058,998; 6,256,968; Canada 1,315,746; and their equivalent international patents. Other patents pending.
First Printing: 3/2004
fits inside Vacuum
(G)
Either
Place Drip Tray into Vacuum Channel. Two bag
guides in Drip Tray help correctly position FoodSaver
Bags when vacuum packaging. Slip open end of bag
into guides before closing lid and vacuum packaging.
After each use, empty Drip Tray and wash in warm
soapy water or place on top rack of dishwasher.
Appliance can be used without Drip Tray.
between paper towel and end of bag so that bag seals
properly with paper towel inside.
Make sure the Vacuum Mode Switch (on V375 only)
is set to Vacuum and Seal.
Make sure you give appliance time to cool down.
Wait at least 20 seconds between seals. Under very
heavy usage, appliance will shut off automatically to
prevent overheating. If it does, wait 20 minutes to
allow appliance to cool off.
If motor runs for more than 30 seconds without
, you may need to adjust bag and try again. If
stopping
you are making initial seal on a piece of bag material with
two open ends, make sure bag is placed on Sealing Strip,
not on black rubber gasket. If you are vacuum packaging
with a bag, make sure open end is placed down inside
Vacuum Channel and make sure Accessory Hose is not
attached. If you are vacuum packaging with an accessory,
check Accessory Hose in appliance lid and in accessory
to ensure a tight fit. (On V375, also make sure Vacuum
Mode Switch is set to
(C)
.)
Vacuum and Seal
Item # TI8-0104 (03/04)