Running The Fetch Application - Videonics PowerScript PS4000S Instruction Manual

Chapter 8

Running the Fetch Application

To run Fetch:
156
1
Locate the Fetch application on your desktop, then open it.
2
Once Fetch starts, the New Connection dialog box appears.
3
Select the text in the Host text box, then enter the address shown above—that is,
192.168.0.2.
4
If any of the other text boxes contain information, select the text and delete it.
5
Click OK. The following Fetch dialog box appears. There is normally a slight delay before
you see the list of directory entries.
You might want to create a shortcut for the PowerScript connection at this time. The
shortcut provides an easy way to make the connection without having to enter the Host
address each time. Once you create the shortcut, you need only select it from the Short-
cuts list to make the connection. See "Creating a Fetch Shortcut to PowerScript" later in
this chapter for instructions.
6 Use the Put File and Get file buttons to transfer files between PowerScript and your com-
puter.
Use Get File when you want to transfer a file from PowerScript to your computer.
The following instructions refer to Fetch version 3.0.3. If
you are using a different version of the application, the
basic procedures should be the same.
You will most likely see other
information in the text boxes
than shown here.
PowerScript Computer Connections