Table of Contents
Advertisement
Chapter 8
Computer Software
The computer to which you want to attach PowerScript must be equipped with PPP soft-
ware. If you are currently accessing the Internet via a serial interface or modem, you
might already have the required software.
If you do not currently have an Internet or network connection, you must obtain the
software by some other means. Some software (such as FreePPP) is available as shareware
over the Internet—all you need to do is find someone with an Internet account. The soft-
ware is also available through User Groups and other on-line services.
In addition, you need a browser application (such as Netscape Navigator) or FTP client
software (such as Fetch) that is capable of Internet protocols. See "Using PowerScript with
Macintosh Fetch" later in this chapter for additional information.
Ethernet PC Card Compatibility
Videonics has conducted numerous tests to determine which Ethernet adapters are com-
patible with PowerScript. Normally, if the Ethernet adapter packaging indicates that the
card is NE2000-compatible , it should work with PowerScript. We have tested the follow-
ing cards and have determined that they are compatible. The specifications, however, are
subject to change.
P
S
/M
OWER
CRIPT
ACINTOSH
This section explains how to configure a Macintosh computer using FreePPP software to
connect to a PowerScript. To set up a Windows-based computer in a similar fashion, see
"Connecting PowerScript with IBM-Compatible Computers" on page 158.
Once you install the necessary cable and the required computer software, you must con-
figure PowerScript to operate over the connection.
Begin by setting up the required IP (Internet Provider) addresses. You must configure
PowerScript to use the same settings as your PPP software. Normally, the settings are:
Check your settings before assuming the above are correct.
These settings affect only the RS-232 connector on the PowerScript rear panel—they do
not affect the mouse connector, even though the connectors look similar (one is male,
the other female).
150
•
Linksys model EC2T
•
ActionTec Ethernet Adapter (part number NE10000-01)
•
EFA PCMCIA Ethernet NE2000 Combo (part number EFA207, model name InfoEx-
press SPC)
Note
If the PC Card packaging indicates that the card is Novell Netware-compatible, but it
does not specifically state NE2000-compatible, it is probably not compatible with
PowerScript.
/F
PPP C
REE
ONFIGURATION
Baud Rate (or Speed) ....... 19.2K
Parity ............................... None
Stop Bits .......................... 1
Data Bits Receive.............. 8
Data Bits Send.................. 8
PowerScript Computer Connections
Hide quick links:
Advertisement
Table of Contents
