Software Upgrade - Motorola PTP 300 series User Manual

8.3.6 Software Upgrade

The 300 Series system has two software image banks; one is a fixed image which is stored in
protected non-volatile memory and cannot be modified by the user. The second bank is used by
the system administrator to upgrade the firmware when necessary.
software upgrade web page.
The 'Fixed' or 'Recovery' image is used by the System Administrator to:
Reset Ethernet configuration to default settings
Erase Configuration
Upgrade software
For a full description of the Recovery image see
The software upgrade pages are used to update a unit's operational software. The software image
to be uploaded should be downloaded to local storage from the Motorola web site. The software
image is delivered by Motorola as a compressed zip file. Once the zip file has been downloaded,
the user should extract the PTP 300 Series Software image, identifiable by its '.dld' file extension.
The first step
downloaded to local storage from the Motorola web site. Once the image is located, the user should
press the "Upload image to wireless unit" button to start the software upgrade process
The software image will now be uploaded to the unit. This upload should only take a few seconds.
Once complete the image is verified and validated to ensure that no errors occurred during transfer
and that the image is valid to run on the current platform. If there are any problems a warning
screen will appear.
16
During the software upgrade process, ensure that the remote end is upgraded first using the wireless connection and
then the local end can be upgraded.
Figure 53 Software Upgrade
(Figure 53) is to use the "Browse" button to locate the software image previously
Web Page Reference
Section 9 "Recovery Mode".
94
Figure 53
shows the main
16
.