Advertisement
Care and Cleaning
CARE AND CLEANING
For best performance and safety,
keep the oven clean inside and out-
side. Take special care to keep the
inner door panel and the oven front
frame free of food or grease build-up.
Never use rough powder or pads.
Wipe the microwave oven inside and
out, including the hood bottom cover,
with a soft cloth and a warm (not hot)
mild detergent solution. Then rinse
and wipe dry. Use a chrome cleaner
and polish on chrome, metal and
aluminum surfaces. Wipe spatters
immediately with a wet paper towel,
especially after cooking chicken or
bacon. Clean your oven weekly or
more often, if needed.
CLEANING THE GREASE
FILTER
The grease filter should be removed
and cleaned often, at least once a
month.
CAUTION
To avoid risk of personal injury
or property damage, do not
operate oven hood without
filters in place.
1. To remove grease filter, slide filter
to the side. Pull filter downward
and push to the other side. The
filter will drop out.
18
2. Soak grease filter in hot water and
a mild detergent. Rinse well and
shake to dry. Do not use ammonia
or place in a dishwasher. The
aluminum will darken.
3. To reinstall the filter, slide it into the
side slot, then push up and toward
oven center to lock.
CHARCOAL FILTER
REPLACEMENT
If your oven is vented inside, the
charcoal filter should be replaced
every 6 to 12 months, and more
often if necessary. The charcoal
filter cannot be cleaned. To order
a new charcoal filter, contact the
Parts Department at your nearest
Authorized Service Center or call
1-800-843-0304 (inside U.S.A) or
1-866-587-2002 (Canada).
1. Unplug oven or turn off power at
the main power supply.
2. Remove the two vent grille
mounting screws. (2 middle
screws)
3. Tip the grille forward, then lift it out.
4. Open the door.
5. Push the hook and remove old
filter.
6. Slide a new charcoal filter into
place and close the door. The fil-ter
should rest at the angle shown.
7. Slide the bottom of the vent cover
into place. Push the top until it
snaps into place. Replace the
mounting screws. Turn the power
back on at the main power supply
and set the clock.
Advertisement
