List Of Symptoms - Brother 888-E30 Operation Manual

List of symptoms

■ Before sewing
Symptom
The needle
threader can not
You have not moved the needle
be used. (For
holder to its highest position.
models equipped
with the needle
threader lever.)
The needle is incorrectly installed.
The sewing lamp is damaged.
The sewing light
does not come on.
The machine is not turned on.
The thread is not passed through the
bobbin-winding thread guide
correctly.
Bobbin spins slowly. (for models
Bobbin thread
equipped with the sewing speed
does not wind
neatly on the bob-
controller.)
bin.
The thread that was pulled out was not
wound onto the bobbin correctly. (For
models equipped with the fast bobbin
winding system.)
The thread does
not pass through
You have not moved the needle
the eye of the
holder to its highest position.
needle. (For mod-
els equipped with
the needle
threader lever.)
The needle is incorrectly installed.
The needle
threader lever
does not lower to
The needle has not been raised to the
the correct
position. (For
correct position.
models equipped
with the needle
threader lever.)
While winding
the bobbin, the
You have not wound the bobbin
bobbin thread
was wound below
thread properly.
the bobbin
winder seat.
Possible cause How to put it right
Raise the needle either by turning the
handwheel toward you
(counterclockwise) so that the mark on
the wheel points up or by pressing
(needle position button) once or twice.
Correctly install the needle.
Contact your retailer or the nearest
authorized service center.
Turn on the machine.
Correctly pass the thread through the
bobbin-winding thread guide.
Move the sewing speed controller to
the right (so that the speed will be fast).
Wind the thread that was pulled off
round the bobbin five or six times
clockwise.
Raise the needle either by turning the
handwheel toward you
(counterclockwise) so that the mark on
the wheel points up or by pressing
(needle position button) once or twice.
Correctly install the needle.
Press the needle position button.
After removing the thread wound
below the bobbin winder seat, wind
the bobbin correctly.
Reference
page 15
page 20
–
page 8
page 11
page 12
4
page 12
page 15
page 20
page 15
page 10
63