Card Reader - HP EliteDesk 800 G3 SFF Maintenance And Service Manual

Card reader

The card reader is attached to the front of the rotating drive cage.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the hard drive cage to its upright position
5. From the inside of the chassis, disconnect the card reader cable from the white system board labeled SD
RDR.
6. Rotate the hard drive cage down to its normal position
60 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page 21).
(Front bezel on page 21).
(Hard drive cage on page
(Hard drive cage on page
20).
41).
41).