Ipv4 Settings; Static Ip - D-Link DVA-2800 User Manual

Section 4 - Configuration
Select Static IP if your ISP provides you with a specific IP address.

IPv4 Settings:

My Internet Select Static IP.
Connection is:
IP Address:
Enter the IP address provided by your ISP.
Subnet Mask:
Enter the subnet mask provided by your ISP.
Default Gateway:
Enter the default gateway address provided by your ISP.
Primary DNS
Enter the primary DNS server IP address assigned by your ISP. This
Server: address is usually obtained automatically from your ISP.
Advanced Settings
Secondary DNS Enter the secondary DNS server IP address assigned by your ISP. This
Server: address is usually obtained automatically from your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
MAC Address
The default MAC address is set to the Internet port's physical interface
Clone: MAC address on the router. You can use the drop-down menu to
replace the Internet port's MAC address with the MAC address of a
connected client.
Enable NAT: Enable or disable Network Address Translation.
Proceed to IPv6 Settings on page 38 or click Save when you are done.
D-Link DVA-2800 User Manual
IPv4 Settings

Static IP

IPv4 SETTINGS
My Internet Connection is: Static IP
IP Address:
Subnet Mask:
Default Gateway:
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
Mac Address Clone:
Enabled
Enable NAT:
⌵
Advanced Settings ...
⌵
⌵
<< MAC Address
33