Cisco Nexus 93180LC-EX Hardware Installation Manual page 46

Configuring Ports
You can individually configure the ports 1 to 28 as indicated in the following table:
Odd Numbered Port (1 to 27)
40-Gigabit QSFP+ port (default)
40-Gigabit port with 4x10-Gigabit
breakout feature
100-Gigabit QSFP28 port
100-Gigabit port with 4x25-Gigabit
breakout feature
1/10-Gigabit port using a
QSFP-to-SFP adapter in the port
You can individually configure ports 29 to 32 as follows:
• 40/100-Gigabit QSFP+/QSFP28 uplink port (default)
• 40/100-Gigabit QSFP+/QSFP28 uplink port can be individually broken out with the 4x10-Gigabit or
4x25-Gigabit breakout feature.
For information on configuring ports for this switch, see the Cisco Nexus 9000 Series NX-OS Interfaces
Configuration Guide .
To determine which transceivers, adapters, and cables this switch supports, see the
Compatibility Information
Cisco Nexus 93180LC-EX NX-OS Mode Hardware Installation Guide
36
Even Numbered Port (2 to 28) below the Odd Numbered Port
40-Gigabit QSFP+ port (default)
Hardware disabled
Hardware disabled
Hardware disabled
1/10-Gigabit port using a QSFP-to-SFP adapter in the port
Note Even numbered port must use the same speed as the odd
numbered port in the same vertical pair of ports. Connect the
odd numbered port first to set the speed for the vertical pair
of ports.
document.
Managing the Switch
Cisco Transceiver Modules