KYMCO XCITING 500 Service Manual page 12

1
. GENERAL INFORMATION
After routing, check that the wire harnesses
are not twisted or kinked.
Wire harnesses routed along with
handlebar should not be pulled tight, have
excessive slack or interfere with adjacent
or surrounding parts in all steering
positions.
When a testing device is used, make sure to
understand the operating methods
thoroughly and operate according to the
operating instructions.
Do you understand
the instrument？
Be careful not to drop any parts.
When rust is found on a terminal, remove
the rust with sand paper or equivalent
before connecting.
Remove Rust！
1-9
XCITING 500/500 AFI/250/300 AFI
Symbols:
The following symbols represent the
servicing methods and cautions included in
this service manual.
: Apply engine oil to the
specified points. (Use
designated engine oil for
Engine Oil
lubrication.)
: Apply grease for lubrication.
Grease
: Transmission Gear Oil (90#)
Gear Oil
＊
: Note