Operating The Power Take Off (Pto); Key; Important; Figure 19 - Toro 74225 Operator's Manual

6. Turn ignition key to start. When engines starts, release

key.

Important

Do not engage starter for more than 10
seconds at a time. If engine fails to start allow 30 second
cool-down period between attempts. Failure to follow
these instructions can burn out starter motor.
7. After the engine starts, move the choke to off
(Fig. 16). If the engine stalls or hesitates, move the
choke back to on for a few seconds. Then move the
throttle lever to desired setting. Repeat this as
required.
2
1
m–4201
Figure 15
1. PTO-On
2. PTO-Off
1
2
m–2720
Figure 17
1. Throttle–Fast
2. Throttle–Slow
Stopping the Engine
1. Push the PTO to off (Fig. 17).
1. Move the throttle lever midway between the slow and
fast positions (Fig. 17).
2. Let the engine idle for 60 seconds (Fig. 18).
3. Turn the ignition key to off (Fig. 18).
4. Pull wire off spark plug(s) to prevent possibility of
5. Close fuel shut off valve, on front panel before
Important
closed before transporting or storing the machine, as fuel
leakage may occur. Set the parking brake before
transporting. Make sure to remove the key as the fuel
pump may run and cause the battery to lose charge.
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
2
Always remove the ignition key and set the
parking brake when leaving the machine
1
unattended, even if just for a few minutes.
m–2719
Operating the Power Take Off
Figure 16
(PTO)
1. Choke–On
2. Choke–Off
The power take off (PTO) switch engages and disengages
power to the electric clutch.
Engaging the PTO
1
1. While seated in the seat, release pressure on the
2
2. Place throttle to the fast position.
3
3. Pull out on the power take off (PTO) switch to engage
M–4268
Figure 18
1. Off
2. Run
3. Start
1. PTO—Off
Disengaging the PTO
1. To disengage push the PTO switch to the off position
20
someone accidentally starting the machine before
transporting or storing machine.
transporting or storing machine.
Make sure that the fuel shut off valve is
Caution
traction control levers and place in neutral.
(Fig. 19).
1

Figure 19

(Fig. 19).
2
m–4201
2. PTO—On