Using Your Steam Mop - Shark S2901 Series Owner's Manual

Using Your Steam Mop

IMPORTANT: Make sure you do not use the
mop without attaching a cleaning pocket and
adding water to the tank first. When you are using
the mop for the first time, it might take longer
than the normal 30 seconds to start steaming.
1
Turn the water tank cap counter clockwise and
remove from the tank. (fig. 3)
2 Use the filling flask and pour water into the tank.
Do not overfill. Replace the cap on the water tank.
(fig. 4)
IMPORTANT: Do not use on unsealed wood
or unglazed ceramic floors. On surfaces that
have been treated with wax or some no wax
floors, the sheen may be removed by the heat
and steam action. It is always recommended to
test an isolated area of the surface to be cleaned
before proceeding. We recommend that you
check the use and care instructions from the floor
manufacturer.
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
4 1 800 798-7398
fig. 3
fig. 4
3
4
5
NOTE: Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
Pull and twist the quick release cord holder to
unwrap the power cord completely. Plug into an
electrical outlet. (fig. 5)
Press the power button to turn the unit on. (fig. 6)
Clean your floors with a forward and backward
motion.
fig. 5
fig. 6