Double Models Specifications & Cavity - Fisher & Paykel DishDrawer DD603 Installation Instructions Manual

DOUBLE MODELS
SERVICES SPECIFICATIONS
WATER CONNECTION
Recommended HOT
(Maximum 140°F/60°C).
/
3
Supplied hose to suit " (9mm)
8
male compression fitting.
WATER SOFTENER MODELS
Refer to your DishDrawer® User Guide for
how to set up your water softener.
WATER PRESSURE
Maximum
Water Softener Models 145 p.s.i. (1000kPa)
Other Models 145 p.s.i. (1000kPa)
DRAIN CONNECTION
3
Drain Hose Joiner to suit Ø / " ±
4
5
Ø1" ± / " waste tees.
64
ELECTRICAL CONNECTION
110-120 VAC power outlet, 9 Amps Minimum.
LENGTH OF SERVICES
(FROM PRODUCT EXIT POINT)
9
Drain hose - 88 / " (2250mm)
16
7
Inlet hose - 68 / " (1750mm)
8
Power supply cord - 44" (1125mm)
NOTE: Services approximately exit product 7
5 1
21 / " (550mm) from front; 31 /
8 4
THE CAVITY
Minimum
14.5 p.s.i. (100kPa)
4.3 p.s.i. (30kPa)
5 5 5
/ ", Ø / " ± / " and
64 8 64
7
/ " (189mm) from left;
16
" (793mm) from top.
+
#
Prefinished model shown
* For an Integrated DishDrawer® the
product depth is specified with an
11
/ " (18mm) Integrated Panel thickness.
16
** Depth of product excludes Curvature (1
or Handle.
TOE KICK DEPTH
Prefinished & Flat Door 2"-4
Integrated 5" (127mm) less the Toe Kick Panel thickness. Minimum Panel
thickness using the supplied screws is
# DOOR FRONT HEIGHT
Prefinished & Flat Door 30 5
1
Integrated 28 / " (717.5mm) minimum.
4
+
locations (refer to step 1 page 7)
NOTE: All depth measurements are taken
from the front face of the adjacent cabinetry.
Be sure the edges of the services hole
are smooth or covered. If the services
hole is through a metal partition the hole
must be protected with the Edge Protector
provided to prevent damage to the power
cord or hoses.
*
**
3
/ " (30mm) Prefinished only,)
16
3
/ " (50-110mm);
8
3
/ " (9mm).
8
/ " (764mm);
64
These marks indicate mounting tab screw
WARNING!
R
3