Burner Removal; Brick Panel Removal; Porcelain Panel Removal; Media Tray Removal (Glass Only) - Napoleon HDX52NT-1 Installation And Operating Instructions Manual

10.3 BURNER REMOVAL

Refer to your burner manual which was shipped separate from the appliance.

10.4 BRICK PANEL REMOVAL

A. Remove the 2 screws securing the brick panel brackets from the top left of the appliance.
B. Remove the left panel. NOTE: Care must be taken with the rear baffl e as it rests on the left and
right panels.
C. Remove the rear baffl e.
D. Repeat step (A) for the right side.
E. Remove the rear panel by lifting it up and out of the rear panel support.

10.5 PORCELAIN PANEL REMOVAL

A. Remove the 4 securing screws from the top / bottom left of the panel inside the fi rebox, remove the
panel.
B. Repeat on the right side.
C. Remove the 4 securing screws from the top and bottom of the rear panel and remove.

10.6 MEDIA TRAY REMOVAL (GLASS ONLY)

A. Vacuum the media from the appliance.
B. Remove the 4 securing screws from the burner media tray and lift up and out, refer to Figure 1.
C. Carefully lift the bottom media tray from the appliance, refer to Figure 2.
Fig. 1
Fig. 2
W415-1371 / 09.15.14
47
EN