Mercury 200 OptiMax Manual page 8

TABLE OF CONTENTS
Troubleshooting
Starter Motor Will Not Crank the Engine.................................... 82
Engine Will Not Start..................................................................82
Engine Runs Erratically.............................................................83
Performance Loss......................................................................83
Battery Will Not Hold Charge.....................................................83
Owner Service Assistance
Local Repair Service.................................................................. 84
Service Away from Home..........................................................84
Parts and Accessories Inquiries................................................84
Service Assistance....................................................................84
Mercury Marine Service Offices.................................................85
Outboard Installation
Important Information................................................................. 87
Avoiding Fuel Flow Restriction..................................................87
Boat Horsepower Capacity........................................................88
Start in Gear Protection.............................................................88
Selecting Accessories for Your Outboard..................................88
Fuel Tanks.................................................................................89
Filling the Fuel System..............................................................89
Installation Specifications..........................................................90
Lifting the Outboard...................................................................90
Steering Cable - Starboard Side Routed Cable.........................91
Steering Link Rod Fasteners.....................................................92
Determining Recommended Outboard Mounting Height...........95
Drilling Outboard Mounting Holes..............................................96
Fastening the Outboard to the Transom....................................98
Electrical, Hoses, Control Cables and Front Clamp................101
Filling the Fuel System............................................................111
Oil Injection Set-Up..................................................................112
Trim In Pin...............................................................................115
viii