Shroud; Cleaning The Air Filter - Stihl MS 362 C-M Instruction Manual

English

Shroud

Removing the Shroud
To switch off the engine, move the
N
Master Control lever in the direction
of STOP or † – when released, the
Master Control lever springs back to
the run position F.
Push the hand guard forward – the
N
chain is locked.
2
1
Open the twist locks (1) by turning
N
them 1/4 turn counterclockwise with
the combination wrench.
Remove the shroud (2).
N
Installing the Shroud
Place the shroud in position.
N
Close the twist locks by turning
N
them a 1/4 turn clockwise.
32

Cleaning the Air Filter

If There is a Noticeable Loss of Engine
Power
Remove the shroud – see "Shroud".
N
Removing the Air Filter
Clean away loose dirt from around
N
the filter.
NOTICE
1
To avoid damaging the filter, do not use
tools to remove or install the air filter.
1 1.
2.
Rotate the air filter a 1/4 turn
N
counterclockwise and lift it away in
the direction of the rear handle.
Always replace damaged filters.
N
Cleaning the Air Filter
Knock out the filter.
N
Spray outside of filter with STIHL
N
special cleaner or soapy water.
Rinse outside of filter under warm
N
running water.
NOTICE
High temperatures and oil can damage
the air filter. Filter efficiency can
deteriorate as a result.
Allow air filter to dry without using
–
any external source of heat.
Do not impregnate the filter with oil.
–
Allow air filter to dry.
N
Install the air filter.
N
Installing the Air Filter
1.
2.
Place the air filter in position.
N
Push the air filter towards the filter
N
housing and turn it clockwise at the
same time until it engages – the
"STIHL" name must be horizontal.
Install the shroud – see "Shroud".
N
MS 362 C-M