Midland EX37 Manual page 10

EX37
Optimum Conditions are:
G Over water
G Open rural areas without obstructions
G Flat areas where you can see the other person
To ensure you get maximum range:
G Be sure to use fresh or fully charged batteries - low batteries will
cause low power conditions.
G Be sure you are on a GMRS channel - FRS channels are
restricted by the FCC to low power.
G Be sure to set your radio to use Hi power.
EX37 QUICK REFERENCE CHART
MENU
Pressing and holding the MONITOR button for 3 seconds will let you
MONITOR
hear noise so you can adjust the volume level of the radio when not
receiving a signal. This could also be used to check any activity on
your current channel before transmitting.
Press and hold the MONITOR button for 3 seconds again to get out
of MONITOR mode.
SCAN
Your radio can scan all 22 channels for activity. To enter, quickly press
the SCAN button. Repeat the same procedure to exit. Your radio will
rapidly scan each of the 22 channels and stop on any active channel
for 6 seconds before resuming scan.
When you press the PTT button to transmit on an active channel, the
scanning function will stop and remain on the active channel. To
resume scanning, quickly press the SCAN button.
Page 9
Channel
CTCSS
oF~38
1~22
Press and hold UP/WX
button for 5 seconds
VOX
On/Off
WX Channel
1~10
Roger Beep
Silent Operation
On/Off
WX Alert
On/Off
midlandusa.com
On/Off