Set-Up And Installation - First Alert AC10-500 User Manual

Set-Up & Installation
DANGER: ELECTRICAL SHOCK HAZARD.
will install this unit at the circuit breaker or fuse box before beginning installation.
Failure to turn off the power before installation may result in serious electrical
shock, injury or death.
IMPORTANT:
!
from the ceiling. When wall mounting, it is suggested that the speaker opening is
in the upper left corner, as indicated by the illustration below.
Tools you will need:
Needle-nose pliers or utility knife
•
Standard phillips screwdriver
•
Wire strippers
•
Ensure the iOS software is updated to iOS 9 and download
the Onelink App from the App Store.
Step 1
Download the free Onelink app from the App
Store and follow set-up instructions.
Step 2
Attach the mounting bracket to the junction box.
Step 3
Using wire nuts, connect the power connector to
the household wiring.
If any unit in the series does not alarm with the test button,
TURN OFF POWER and recheck connections. If it does not
alarm with the test button when you restore power, replace
it immediately.
Improper wiring of the power connector or the wiring leading to the power connector will cause damage to the
Alarm and may lead to a non-functioning Alarm.
The top edge of the Alarm MUST be between 4 and 6 inches down
Turn off power to the area where you
Speaker
Opening
}
A
5
4
3
2
1
1. Smoke/CO Alarm
2. Ceiling or Wall
3.
Power Connector
4. Wire Nut
}
6
7
8
5
4
3
1
5. Junction Box
6. Neutral Wire (white)
7.
Interconnect Wire (orange)
8. Hot Wire (black)
B
9