D-Link DSL-2750U User Manual page 30

Section 3 – Web Configuration
If the security mode is set to None, your wireless network can be connected by
all wireless clients that can detect the SSID of this network.
If the Security Mode is set to Auto(WPA or WPA2), WPA only, or WPA2 only,,
the page is shown as the right figure appears. Take Auto(WPA or WPA2) as an
example.
Step 1 In Security Mode drop-down list, select Auto(WPA or WPA2).
Step 2 In WPA Encryption drop-down list, select TKIP+AES.
Step 3 Configure the WPA Mode.
- Auto(WPA or WPA2)-PSK: WPA-PSK does not require an
authentication server. You need to set a Pre-shared Key (wireless
network password) for your wireless network.
- Auto(WPA or WPA2)-Enterprise: When WPA enterprise is enabled,
the router uses EAP (802.1x) to authenticate clients via a remote
RADIUS server. Enter the port, IP address, and password of the
Radius server. The wireless clients are required to enter the
username and password provided by the Radius server.
Step 4 Set the Group Key Update Interval. For higher security, WPA password
is updated periodically. This value is the update interval of the WPA
password. You can keep it as default.
Step 5 Set wireless password in Pre-Share Key text field.
Step 6 After setting, click Apply to save the settings.
D-Link DSL-2750U User Manual
28