Hitachi P50H401/DW3 Service Manual page 32

Front Panel Controls
POWER light indicator
To turn the TV ON, press the main power
switch located on the lower right side of the
TV. A red stand-by indicator lamp located on
the lower right corner of the front bezel will
illuminate. The Plasma TV is now ready for
remote ON/OFF operation.
Indicating Lamp Power Status
Off
Lights
Red
Lights
Blue
Lights
Orange
(Power Saving)
Blinking
Blue 3 times
REMOTE CONTROL sensor
Point your remote at this area when selecting
channels, adjusting volume, etc.
INPUT- FRONT JACKS
INPUT- FRONT provide composite Video jacks for
connecting equipment with this capability,
such as a DVD player or Camcorders.
NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input
when INPUT : 1, 2, 3, Front and HDMI 1, 2 , Front. Check the Power Light to make sure the TV
is turned off or in Stand-by mode (lights red) when not in use.
2. Remote Control can not turn ON/OFF the "MAIN POWER" of the TV.
OFF. When the main power switch is set to Off.
OFF.
When the main power switch on the TV is ON.
(Stand-by)
On TV MAIN POWER is ON ; picture is shown.
TV MAIN POWER is ON with no signal input
Off
except antenna (no sync. signal).
When TV receive the IR signal once from R/C.
On
Indicating Lamp
Operating
31
R/C sensor