Firmware Update - Fujitsu CELVIN NAS QE705 Operating Manual

Firmware update

Firmware update

When updating the firmware, the mains power and network connection must not be
!
disturbed. Do not switch the NAS off during a firmware update under any circumstances.
If the system is running properly, then there is no need to update the firmware.
i
Before updating the system firmware, make sure the product model and firmware version are correct.
Follow the steps below to update the firmware:
► Please visit http://www.fujitsu.com/fts/support and read the release notes for the new firmware
version to check if it is necessary to update the firmware.
► Before updating the system firmware, back up all data stored on the hard disk to avoid any data
being lost during the system update.
► Open the Administrator screen and select Control Panel – Update Firmware – Update Firmware.
► Click Browse... to select the new firmware image for the system update.
► Select the corresponding IMG file and then click on Update system to update the firmware.
The system update may take anywhere from a number of seconds to several minutes to
i
complete, depending on the network connection status. Please be patient. The system will
display a message when the system update is completed.
50 Fujitsu