Table of Contents
Advertisement
Detergent and
dishwasher use
Measuring out the detergent
GB
Good washing results also depend on the correct amount of
detergent being used. Exceeding the stated amount does not
result in a more effective wash and increases environmental
pollution.
The amount can be adjusted to the soil level.
In the case of normally soiled items, use approximately either
25g (powder detergent) or 25ml (liquid detergent). If tablets
are used, one tablet will be enough.
If the crockery is only lightly soiled or if it has been rinsed
with water before being placed in the dishwasher, reduce
the amount of detergent used accordingly.
For good washing results also follow the instructions shown
on the detergent box.
For further questions please ask the detergent producers.
Open the detergent dispenser using button D and measure out
the detergent according to the Table of wash cycles:
from the edges of the compartment and close cover C until it
clicks.
The detergent dispenser automatically opens up at the right time
according to the wash cycle.
If all-in-one detergents are used, we recommend using the TABS
option, because it adjusts the cycle so that the best washing and
drying results are always achieved.
Only use detergent which has been specifically designed
for dishwashers.
DO NOT USE washing up liquid.
Using excessive detergent may result in foam residues
remaining in the machine after the cycle has ended.
To achieve the best washing and drying results, the combined
use of detergent, rinse aid liquid and refined salt is required.
We recommend using detergents that do not contain
phosphates or chlorine, as these products are harmful
to the environment.
*
Only available in selected models.
10
• powder or liquid: compartments
A (wash detergent) and B (pre-
wash detergent)
• tablets: when the cycle
requires 1 tablet, place it in
compartment A and close cover
C; when it requires 2 tablets,
place the second tablet on the
bottom of the appliance.
Remove detergent residues
Starting the dishwasher
1. Turn the water tap on.
2. Press the ON/OFF button:
3. Open the door and pour in a suitable amount of detergent.
(see Detergent)
4. Load the racks (see Loading the racks) and shut the door.
Select the wash cycle by turning the WASH CYCLE
5.
SELECT knob clockwise: align the notch in the knob with
the number/symbol representing the desired wash cycle. The
START/PAUSE indicator light will go on.
*
6. Select the wash options
options.)
7. Start the cycle by pressing the Start/Pause button: a beep
*
the indicator light corresponding to the wash
will sound
and
phase will go on to signal that the cycle has begun.
*
8. At the end a few beeps
will signal the end of the wash cycle
and the END indicator light will go on.
Switch off the appliance by pressing the ON/OFF button.
9. Wait for a few minutes before removing the crockery - to
avoid burns. Unload the racks, beginning with the lower level.
The machine will switch off automatically during long
periods of inactivity in order to minimise electricity
consumption.
*
AUTO WASH CYCLES
equipped with a special sensor which can be used to assess
the level of soiling and automatically select the most efficient and
economic wash cycle accordingly. The duration of the auto wash
cycles may vary due to the operation of the sensor.
Changing a wash cycle in progress
If a mistake was made in the wash-cycle selection process, it is
possible to change the cycle provided that it has only just begun:
Once the wash cycle has started, in order to change the wash
cycle switch off the machine by pressing and holding the ON/
OFF/Reset button. Switch it back on using the same button and
select the desired wash cycle and options.
Adding extra crockery
Press the Start/Pause button - the corresponding indicator light
will flash. Open the door, taking care to avoid the escaping
steam, and place the crockery inside the appliance. Press the
Start/Pause button (fixed light): the cycle starts again.
If the Start/Pause button is pressed so as to pause the
machine, both the wash cycle and the Delayed Start function (if
selected) are interrupted.
At this stage the wash cycle cannot be changed.
Accidental interruptions
If the door is opened during the wash cycle or there is a power
cut, the cycle stops. It starts again from the point at which it
was interrupted once the door has been shut or the electricity
supply restored.
(see Special wash cycles and
:
some models of dishwasher are
Advertisement
Table of Contents
