Samsung SNB-6010 User Manual page 35

Setting up port range forward for several network cameras
When several network cameras are connected to one Broadband Router device, you
should forward the TCP 943 port of the router to the TCP 943 port of a connected camera.
If you don't set properly the TCP 943 port of the router, you cannot get any video stream from the
`
J
web page of the camera.
• TCP 943 port is a port for the Silverlight policy server of a camera.
• You can set a rule of Port Forwarding on the Broadband Router device through its
configuration web page.
• You cannot change the Silverlight policy server port of a camera.
• You can change the ports of the camera except the policy server port through its
configuration web pages.
When Camera1 and Camera2 are connected to a router :

User
Broadband Router
Start End
943 943
3000 3000
3001 3001
4520 4520
4521 4521
8080 8080
8081 8081
Port forwarding can be done without additional router setup if the router supports the UPnP
`
M
(Universal Plug and Play) function.
After connecting the network camera, set <Quick connect> of <Samsung DDNS> to <On> in
the "Setup  Network  DDNS" menu.
Internet

Protocol IP Address
TCP 192.168.1.100
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
TCP/UDP 192.168.1.100
TCP/UDP 192.168.1.101
Camera1 (192.168.1.100)
HTTP Port

Device port
RTSP Port
Policy Server Port
Camera2 (192.168.1.101)
HTTP Port

Device port
RTSP Port
Policy Server Port
8080
4520
3000
943
8081
4521
3001
943
English _35