Table of Contents
Advertisement
2 - Click Antenna/Cable Installation > Automatic Channel
Update and click Off.
3 - Press BACK repeatedly if necessary, to close the menu.
When new channels are found or if channels are updated or
removed, a message is shown at TV start up. To avoid this
message to appear after every channel update, you can switch it
off.
To switch off the message...
1 - Press and press (left) Setup.
2 - Click Antenna/Cable Installation > Channel Update
Message and click Off.
3 - Press BACK repeatedly if necessary, to close the menu.
In certain countries, the Automatic channel update is done while
watching TV or on any moment when the TV is in Standby.
Manual Channel Update
You can always start an channel update yourself.
To start a channel update manually...
1 - Press and press (left) Setup.
2 - Click Antenna/Cable Installation > Search for Channels and
click Update.
3 - Follow the instructions on screen. The update may take a
few minutes.
New channels
In the Channel List, newly found channels are marked with a .
To open a list of only the new channels...
1 - Press LIST to open the Channel List.
2 - Press OPTIONS and click Show New Channels. You can
mark a channel as a favourite, lock or rename a channel.
3 - Press the colour key
channels.
Reinstall Channels
Reinstall Channels
You can reinstall all channels and leave all other TV settings
untouched.
If a child lock code is set, you will need to enter this code before
you can reinstall channels.
To reinstall channels...
1 - Press and press (left) Setup.
2 - Click Antenna/Cable Installation > Search for Channels and
click Reinstall.
3 - Follow the instructions on screen. The installation may take a
few minutes.
Close to close the list of new
Reinstall TV
You can redo a full TV installation. The TV is completely
reinstalled.
To redo a full TV installation...
1 - Press and press (left) Setup.
2 - Click General Settings and click Reinstall TV.
3 - Follow the instructions on screen. The installation may take a
few minutes.
Factory Settings
You can set the TV back to the original TV settings (the factory
settings) for picture, sound and Ambilight.
To switch back to the original settings...
1 - Press and press (left) Setup.
2 - Click General Settings and click Factory Settings.
3 - Press BACK repeatedly if necessary, to close the menu.
Channel List Copy
Introduction
Channel List Copy is intended for dealers and expert users. In
some countries, Channel List Copy is only available for copying
satellite channels.
With Channel List Copy, you can copy the channels installed on
one TV onto another Philips TV of the same range. With
Channel List Copy, you avoid the time-consuming channel
search by uploading a predefined channel list on a TV. Use a
USB flash drive of minimum 1 GB.
Conditions
• Both TVs are from the same year range.
• Both TVs have the same hardware type. Check the hardware
type on the TV type plate on the back of the TV. Typically
noted as Q . . . LA
• Both TVs have compatible software versions.
Current software version
You can check the current version of the TV software with
in Setup > Update Software > Current Software Info.
Copy Channel List
To copy a channel list...
1 - Switch on the TV. This TV should have channels installed.
2 - Plug in a USB flash drive.
3 - Press and press (left) Setup.
4 - Click General Settings > Channel List Copy and click Copy
to USB. You might be asked to enter the Child Lock PIN code
to copy the channel list.
82
Advertisement
Table of Contents
