Honda CRF230F 2007 Owner's Manual page 108

RIGHT REAR
(9)
(7) lug
(8) slot
(9) brake panel
Installation
1. Reverse the removal procedure. Install the
side collar into the wheel. Make sure the lug
( ) on the swingarm is located in the slot 7
( ) in the brake panel ( ). Check that the 8
chain adjusters are installed properly.
(7)
2. Adjust the drive chain (page
3. Tighten the rear axle nut to the specified
torque:
80 lbf·ft (108 N·m , 11.0 kgf·m)
(8)
4. Adjust the rear brake (page
5. Apply the rear brake, release it, then spin the
wheel and check that it rotates freely. Repeat
this procedure several times.
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
Wheels
9
110 ).
90 ).
Servicing Your Honda
99