Battery Disposal - Husqvarna R146S Manual

BLADE
 To remove the blade (23) unscrew the screw
(24).
 Check the conditions of the blade-support (25), the
washer (26), the key (27) and the washer (28) and
replace any parts which are damaged.
KIT ELECTRIC STARTING
 Before starting the motor for the first time, you
are advised to keep the battery on charge for 2
to 3 hours.
If the battery proves to be low during starting, charge it
for 24 hours.
When starting, don't keep trying to start for more than
5 seconds.
BATTERY MAINTENANCE
IMPORTANT
For correct battery maintenance (29), especially in prepa-
ration for a long period of inactivity, and for recharging, it
is not necessary to remove it from its casing, but to simply
proceed as follows:
1) Remove contact (30
2) Store the battery in a fresh and dry place.
3) Recharge the battery before use at room temperature
for 24-36 hours.
4) Restore the contact (30) before use
GUARANTEE AND GUARANTEE POLICY
f any part is found to be defective due to faulty manufacture
I
within the guarantee period, Husqvarna Outdoor Products,
through its Authorised Service Repairers will effect the repair
or replacement to the customer free of charge providing:
a) The fault is reported directly to the Authorised Re-
pairer.
b) Proof of purchase is provided.
c) The fault is not caused by misuse, neglect or faulty
adjustment by the user.
d) The failure has not occurred through fair wear and
tear.
e) The machine has not been serviced or repaired, taken
apart or tampered with by any person not authorised by
Husqvarna Outdoor Products.
f) The machine has not been used for hire.
g) The machine is owned by the original purchaser.
h) The machine has not been used commercially.
 This guarantee is additional to, and in no way diminishes
the customers statutory rights.
Failures due to the following are not covered, therefore
it is important that you read the instructions contained in
this Operator's Manual and understand how to operate
and maintain your machine:
5
ENGLISH -
 When reassembling, make sure that the key (271) is
correctly seated in the shaft and that the cutting edges
face in the direction of the engine rotation. The blade
screw (24) must be torqued to 5,34 Kgm (52,4 Nm).

BATTERY DISPOSAL

Those batteries marked with a "crossed out
waste disposal bin" and bearing the chemical
symbol Pb (battery containing lead) are not to
be disposed in domestic waste bins.
The user is legally obliged to take the used
batteries to special collection points or to return
them to the retailer.
Pb
Failures not covered by guarantee
- Replacing worn or damaged blades
- Failures as a result of not reporting an initial fault.
- Failures as a result of sudden impact.
- Failures as a result of not using the product in accordance
with the instructions and recommendations contained in
this Operator's Manual.
- Machines used for hire are not covered by this gua-
rantee.
- The following items listed are considered as wearing parts
and their life is dependent on regular maintenance and
are, therefore not normally subject to a valid warranty
claim: Blades, Electric Mains cable, Belt
 CAUTION!
Husqvarna Outdoor Products does not accept liability
under the warranty for defects caused in whole or part,
directly or indirectly by the fitting of replacement parts
or additional parts that are not either manufactured or
approved by Husqvarna Outdoor Products, or by the
machine having been modified in any way.