Table of Contents
Advertisement
Move - Moving a channel or a selection of channels can be done using drag and drop options. Select the TV channel
and move it to desired position. Moving a channel will cause renumbering of the channels.
Note: you cannot assign numbers to TV channels, channel numbers will be assigned based on arranged list.
Move is possible only in the same subcategory; moving channel from DVB-S to Analogue will display the message
below (Error! Reference source not found.):
Limitations and constraints
Service name length is not explicitly defined in DVB standard. Only limitation is the size (8bit) reserved for the value
in SDT descriptor that defines the service name length, this compiles to 255 char string.
Channel number or LCN can take values from 1 – 9999 as it is defined in the code. These limitations are applied in
the editor.
Save – when the channel list is according with the requirements press "Save" button for saving the channel list. This
option will rewrite the open file and save it in the same location.
If you want to save the file in another location please use the "Save As" option from the File menu.
3. Import channel list to TV
To import the channel list back to the TV requires the USB drive with the file channelTable.xml saved on the root of
the drive. To import the channel list back to the TV the following steps should be followed (make sure that Hotel
mode is set to OFF):
1. Insert the USB key on the side connector of the TV.
2. Enter the MENU and navigate to Channel list.
3. Select the option "Import Channel list to USB".
4. When the process is complete remove the USB key.
Do check the channel list before saving the cloning data.
Image 1-8 - Info message
36
Advertisement
Table of Contents
