Cub Cadet 37 HP Tank 72 Operator's Manual page 11

4. Install the upper ROPS section onto the lower ROPS "posts".
Install the (1⁄2-13 x 3.25) HHCS bolts, nuts and washers. See
Fig. 3-3.
Hex Bolts
Washers
Lower ROPS Posts
Figure 3-3
5. Tighten Upper ROPS section bolts after both RH & LH
hardware is installed.
6. Tighten the frame mounting hardware to 80-90 lb.-ft.
torque. See Fig. 3-2.
NOTE: Make sure tubular upright posts are absolutely tight
within welded bracket.
7. Insert rubber plugs into each side of the upper ROPS. See
Fig. 3-4.
Rubber Plug
Figure 3-4
Nuts
8. Move the upper ROPS section to the upright position, and
insert the locking pins with their retainer hairpin clips. See
Fig. 3-5.
Locking Pin
Figure 3-5
Position Drive Control levers
The drive control levers of the tractor are lowered for shipping
purposes. Using the hardware found in the manual bag, the
control levers must be repositioned to operate the tractor. To
reposition the control levers for operation, proceed as follows:
1. Lift and swing the control levers up into the operating
position.
2. From the outside, insert the bolts through the hourglass
spacers and the holes of the pivot bracket. Secure with the
flange lock nuts. See Fig. 3-6.
Bolt
Figure 3-6
3. Refer to "Adjusting Drive Control Levers" section for
instructions on the final adjustment of the levers.
s
ectiOn
Hairpin
Clips
Nut
Hourglass
Spacer
2 — a & s -u
sseMbly et p
11