Controlled Cold, End Of Cycle Beeps, Auto Water Level - Fisher & Paykel WA75T65GW1 Installation Instructions And User Manual

Controlled cold
EXCELLENCE model only
If your cold water temperature is very low you will not get a very effective wash. The
CONTROLLED COLD option solves this problem by adding a small amount of hot water to raise
the temperature of the wash. We have called this "CONTROLLED COLD".
Select COLD wash temperature.
1
The wash progress lights show the temperature adjustment possible.
2
When the first progress light is on, the machine will fill with cold water only.
Press the ADVANCE button to select the second light and your Smart Drive™ will control
the temperature to approximately 20°C. Each following light equals approximately a
1°C temperature rise.
Note: if you always use COLD or CONTROLLED COLD water, we recommend that a WARM or HOT
wash be used regularly, eg every 5th wash should be at least a warm one.
Fig.30 Changing the wash temperature setting
End of cycle beeps
EXCELLENCE model only
The beeps signalling the end of the cycle can be increased or decreased. Press the options
button up to increase beeps or down for no beeps.
Auto water fill level
EXCELLENCE model only
If you are not satisfied with the level that your
Smart Drive™ fills to on AUTO water level, you can
increase or decrease the fill level that AUTO will select.
Note: if you feel there is not enough water for the
load, we recommend you check by pausing the
machine and pushing the clothes down to see how
much spare water is at the bottom of the bowl.
Clothes often float and your Smart Drive™ can sense
the water under the clothes.
Changing pre-set options
Light on
FAVOURITE
EASY IRON
ALLERGY
HAND WASH
HEAVY DUTY
25
Option
less water
factory setting
more water +
more water ++
more water +++