Table of Contents
Advertisement
8. Set the Console Base (83) face down on a soft
surface to avoid scratching the Console Base.
Remove the two Screws (A) from the Pulse
Crossbar (31). Remove the Pulse Crossbar.
Discard the Screws.
9. IMPORTANT: To avoid damaging the Pulse
Crossbar (31), do not use power tools and do
not overtighten the #10 x 3/4" Screws (13).
Orient the Pulse Crossbar (31) as shown. Start
one #10 x 3/4" Screw (13) with one #10 Star
Washer (11) into each end of the Pulse Crossbar
and each of the Handrails (71, 72). Then, start
another #10 x 3/4" Screw and #10 Star Washer
into each end of the Pulse Crossbar. Start all
four Screws, and then tighten them.
Insert the Console Frame (87) into the Handrails
(71, 72). Attach the Console Frame with four
1/4" x 1" Screws (9). Start all four Screws, and
then tighten them. Be careful not to pinch the
Upright Wire (70).
4
8
A
31
9
87
13
11
9
71
70
11
83
13
11
9
31
72
Advertisement
Table of Contents
