Notes About The Toner - Ricoh SP 310 DN User Manual

7. Appendix

Notes About the Toner

• Proper operation cannot be guaranteed if any third-party toner is used.
• Depending on printing conditions, there are cases where the printer cannot print the number of
sheets indicated in the specifications.
• Replace the print cartridge if the printed image suddenly becomes pale or blurred.
• When operating the machine for the first time, use the print cartridge supplied with this machine. If
this cartridge is not initially used, the following problems may occur:
• Toner/Paper End indicator will flash before the toner runs out.
• Toner/Paper End indicator will light up when the toner runs out, but instead the printed image
suddenly becomes pale or blurred.
• To continue printing after Toner/Paper End indicator light up, set [Toner End Option Settings] to
[Continue Printing] using Smart Organizing Monitor. However, since any trouble caused by using
this setup is outside of the scope of the manufacturer's warranty, this setup should be used with
care. For details about [Toner End Option Settings], see the Smart Organizing Monitor Help.
• If [Toner End Option Settings] is first set to [Continue Printing] and then to [Stop Printing], be sure to
use a new print cartridge. If a used print cartridge is installed, there will be a discrepancy between
the remaining toner level displayed and the actual remaining toner, and accordingly, Toner/Paper
End indicator will not flash at the appropriate timing.
• The lifetime of the photo conductor, which is built into the print cartridge, is taken into account when
Toner/Paper End indicator flashes. If the photo conductor stops working before the toner runs out,
Toner/Paper End indicator may flash.
100