Parameter Format; Command Example - Panasonic PT-LB51NT Specifications

S F
P E C I L
Micro-Portable Wireless LCD Projector

Parameter format

Parameter format Size (Byte)
<pl> 3 (1 or 2 bytes also
possible when
under control)
<off on> 1
<input signal> 3
<installation> 1
<language> 3
<power condition> 3
<lamp condition> 1
<acctch> 4
<lamp power> 1
<color temp> 1
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.

Command example

To set the volume to +30, send the command as shown below.
STX
Start
NOTE: When sending commands without parameters, a colon (:) is not necessary.
As of May 2007
E
Difinition
Dicimal without signs: 0-999 (000, 001, 002...999)
Dicimal with signs: -99 to +99 (-99...-01, +00, +01, +02...+99)
Callback from the projector is 3 Byte.
0 = off, 1 = on
RG1 = computer 1, RG2 = computer 2, NWP = network,
VID = video, SVD = S-Video
0 = front, 1 = rear, 2 = ceiling and front, 3 = ceiling and rear
ENG = English, DEU = German, FRA = French, ESP = Spanish,
ITL = Italian, JPN = Japanese, CHI = Chinese, POR = Portuguese,
SVE = Swedish, NOR = Norwegian, DAN = Danish, POL = Polish,
CES = Czech, MAG = Hungarian, RUS = Russian, THA = Thai, KOR = Korean
000 = power on (standby mode on), 001 = power off (standby mode off)
0 = standby, 1 = lamp on under control, 2 = lamp off,
3 = lamp off under control
Dicimal without signs: 0000-9999 hours
0 = economy, 1 = normal
0 = low, 1 = standard, 2 = high
AVL : 30
Command Parameter
ETX
End
PT-LB51NT
< 9 >