Step 10 Wiring Connections - Samsung DMT800 Series Installation Manual

STEp 10 WIrING cONNecTIONS

1. Before connecting the power cable to the dishwasher, make sure to turn off the circuit
breaker.
2. Check to remove the junction box cover located at the bottom right at the front of the
dishwasher. You will find three power wires from the dishwasher including the grounding line.
3. Connect the power cable to the dishwasher.
Twist and connect each wire using wire connectors. When using wire connectors, insert each
wire as shown in Figure 14 and rotate the wire connector.
4. Recheck whether the power cable is connected correctly.
(Each colored wire should be connected to its opposite wire of the same color. White should
be connected to white, black to black, and green to green.)
5. Replace the junction box cover on the dishwasher.
<Figure 13>
<Figure 14>
installation_DD68-00046A-03_EN.indd 17
power cable
Junction box
Strain relief
Black to black
White to white
Green to green
(Ground to ground)
installing the dishwasher _17
2010-10-19 2:25:04