Apply Power - Select Dialing Method; 10. Transmitter Installation Options; 11. Installing Single Transmitters; 12. Installing Multiple Transmitters - Linear PERS-2400A Installation And Operation Instructions Manual

9. APPLY POWER - SELECT DIALING METHOD

TURN POWER
SWITCH ON
NOTE: THE DEFAULT DIALING METHOD IS TONE DIALING
IF REQUIRED, CHANGE THE DIALING METHOD
BY PRESSING AND HOLDING THE HOME & CLEAR
BUTTONS WHILE SWITCHING THE POWER ON
• 7 BEEPS SOUND FOR PULSE DIALING
• 8 BEEPS SOUND FOR TONE DIALING

11. INSTALLING SINGLE TRANSMITTERS

ADDS ONE TRANSMITTER AT A TIME
PRESS CLEAR BUTTON
1
FOR 5 SECONDS
• 5 BEEPS SOUND
(TX ADD MODE)
ACTIVATE TRANSMITTER
2
• 1 BEEP SOUNDS
(TX ADDED)
CONSOLE REVERTS
TO OPERATE MODE
NOTE: IF THE CONSOLE'S MEMORY
IS FULL, ONE LONG BEEP SOUNDS WHEN
TRYING TO ADD A TRANSMITTER
REPEAT STEPS 1 & 2 FOR ADDITIONAL
3
TRANSMITTERS (UP TO 16 TOTAL)
NOTE: PRESS CLEAR BEFORE TRANSMITTING TO RETURN
TO OPERATE MODE WITHOUT ENTERING A TRANSMITTER
• 2 BEEPS SOUND WITH ACTIVITY TIMER ENABLED
• 3 BEEPS SOUND WITH ACTIVITY TIMER DISABLED
THE CONSOLE WILL RETURN TO OPERATE MODE
AUTOMATICALLY AFTER 30 SECONDS
ON
DXS-21
DXS-63

10. TRANSMITTER INSTALLATION OPTIONS

FOR ALL TWO-BUTTON TX'S EXCEPT DXS-63
WHEN IT IS
INSTALLED
WITH THE
LEFT BUTTON
WHEN IT IS
INSTALLED
WITH THE
RIGHT BUTTON
FOR DXS-31 STATIONARY TRANSMITTERS
WHEN IT IS INSTALLED
WITH THE JUMPER SET
FOR DELAY
IT WILL
FUNCTION
AS EMERGENCY
FOR MODEL DXS-32: CUT JUMPER (INSTANT TX) FOR USE
AS AN ACTIVITY TX. SEE DXS-32 INSTALLATION INSTRUCTIONS

12. INSTALLING MULTIPLE TRANSMITTERS

ADDS MULTIPLE TRANSMITTERS
PRESS TEST BUTTON
1
• 4 BEEPS SOUND
(TEST MODE)
2
PRESS TEST BUTTON AGAIN
• 5 BEEPS SOUND
(ADD TX MODE)
NOTE: EACH TIME THE TEST BUTTON IS PRESSED IN THE ADD TX MODE,
THE CONSOLE WILL BE READY TO INSTALL A TRANSMITTER IN THE NEXT
AVAILABLE SENSOR ZONE LOCATION. IF THE VB-4 VOICE BOARD IS
INSTALLED, THE CONSOLE WILL ANNOUNCE THE SENSOR ZONE LOCATION
NUMBER.
3 ACTIVATE TRANSMITTER
• 1 BEEP SOUNDS
(TX ADDED)
NOTE: IF THE CONSOLE'S MEMORY
IS FULL, ONE LONG BEEP SOUNDS
WHEN TRYING TO ADD A TRANSMITTER
REPEAT STEPS 2 & 3 FOR
4
ADDITIONAL TRANSMITTERS
(UP TO 16 TOTAL)
PRESS CLEAR TO RETURN TO OPERATE MODE
5
• 2 BEEPS SOUND WITH ACTIVITY TIMER ENABLED
• 3 BEEPS SOUND WITH ACTIVITY TIMER DISABLED
THE CONSOLE WILL RETURN TO OPERATE
MODE AUTOMATICALLY AFTER 3 MINUTES
IT WILL
ACTIVATE
USING
EITHER
BUTTON
IT WILL ONLY
ACTIVATE
USING BOTH
BUTTONS
WHEN IT IS INSTALLED
WITH THE JUMPER SET
FOR INSTANT
IT WILL
FUNCTION
AS ACTIVITY
DXS-21
DXS-63
3