Operation; Using The Blender - Hamilton Beach Tango Series Operation Manual

Operation

Operating the Blender–Model 91300
wWARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Controls
Two separate switches on the front panel allow you
to control the blender for precise blending
requirements:
• The On/Off switch will turn the blender On for
continuous operation or Off.
• The Pulse position on the On/Off switch
(Model 91300 only) turns on the blender only
when the switch is pressed. When the switch is
released, the blender will stop. This will allow you
to precisely control the operation of the blender.
• The Hi/Low switch allows you to select the
following speeds:
Hi – 20,000 RPM Low – 18,500 RPM

Using the blender

Before you use the blender for the first time, wash
the container, cover, and cutter unit assembly.
Refer to "Cleaning Instructions." Do not put the
cutter assembly in the dishwasher.
To operate the blender, proceed as follows:
1. Place the blender on a clean, dry, level surface,
and set the On/Off switch to Off.
2. Place cutter unit in the threaded collar, blades up.
Slip the gasket OVER the blades and onto the
base of the cutter assembly. Screw the
completed cutter assembly onto the container.
wWARNING
Cut Hazard
Always place cover on jar when blending.
Do not put hands, spoons or other utensils
in jar when blending.
Failure to follow these instructions can
result in broken bones, cuts or other injuries.
On (I) /
Off (O) /
Pulse
Switch
Model 91300
3. Plug the blender into an electric outlet.
4. Place the ingredients to be blended into the
container.
5. Place the container onto the base. Make sure it
rests securely on the base.
6. Place the cover and filler cap on the container.
7. Set the Hi/Low switch to the desired speed. See
"Professional Blending Techniques" for blending
tips.
NOTE: If you want the blender to run for short
bursts, press the Pulse switch. While you are
pressing the Pulse switch, the blender will run at
the selected speed. Release the Pulse switch to stop
the blender.
Hi/Low
Switch
5