Using Fm Traffic; Led Blink Codes - Garmin 715 Owner's Manual

Using FM Traffic

Using FM Traffic
The traffic receiver is included in some
nüvi 715, 755T, 765, and 775 packages.
Use an FM TMC (Traffic Message
Channel) traffic receiver to receive
traffic information broadcast over the
FM Radio Data System. For information
about FM traffic receivers and coverage
areas, see www.garmin.com/traffic.
noTe: Garmin is not responsible for
the accuracy of the traffic information.
The FM traffic receiver simply
receives signals from the traffic service
provider and shows that information
on your nüvi.
noTe: The FM traffic receiver and
nüvi must be in data range of an FM
station transmitting TMC data to
receive traffic information.

noTe: You can only access the traffic
information if the nüvi is connected to
an FM traffic receiver.
noTe: If your FM TMC traffic
receiver has an antenna with suction
cups on it, route the antenna on your
windshield vertically using the suction
cups.

LED Blink Codes

The green Power LED lights when
connected to external power. The Status
LED indicates the signal reception:
• Yellow dot-dash flashes: determining
which country you are currently in.
• Yellow solid: searching for signal.
• Red solid: momentary sync loss.
nüvi 705 Series Owner's Manual