D-Link DSL-G604T User Manual page 35

DSL-G604T Wireless ADSL Router Manual
Step 2.2: Static IP Address
The following window is used to set the Static IP
mode for the Router. A Static IP address is used
whenever a known static IP is assigned. The
accompanying information such as the Subnet mask,
ISP Gateway Address and DNS servers should also
be specified in order to be able to connect. These are
the servers would enable you to have access to other
web servers. Valid IP addresses range from 1.0.0.1 to
255.255.255.255.
To configure the connection for Static, perform the
steps listed below. Some of the settings do not need
to be changed the first time the device is set up, but
can be changed later if you choose. After setting the
value listed, click the Next button to go to Step 4 of
the Configuration Wizard.
Figure 3-. Set Static IP window
35