D-Link DSL-562T User Manual page 10

Information you will need about your LAN or computer:
Ethernet NIC
USB port
DHCP Client status
It is recommended that your collect and record this information here, or in some other secure place, in case you
have to re-configure your ADSL connection in the future.
Once you have the above information, you are ready to setup and configure your DSL-562T ADSL Router.
The Modem may be reset to its factory default settings by performing a Restore settings
operation within the management interface, see System Commands for more
information. If you cannot gain access to the management interface, you may opt to use
Note
the Reset button on the rear panel of the device (see Factory Reset Button below).
DSL-562T DSL Router User's Manual
If your computer has an Ethernet NIC, you can connect the
DSL-562T to this Ethernet port using an Ethernet cable.
You can also use the Ethernet port on the DSL-562T to
connect to other Ethernet devices, such as a Wireless
Access Point.
If your computer has an available USB port, you can
connect the DSL-562T to this USB port using a USB cable.
Your DSL-562T ADSL Modem is configured, by default, to
be a DHCP server. This means that it can assign an IP
address, subnet mask, and a default gateway address to
computers on your LAN. The default range of IP addresses
the DSL-562T will assign are from 192.168.1.2 to
192.168.1.254. Your computer (or computers) needs to be
configured to Obtain an IP address automatically (that is,
they need to be configured as DHCP clients.)
x
Record info here